2 Channel Class D High Stability Digital Power Amplifier
4 Channel Class D High Stability Digital Power Amplifier
6 Channel Class D High Stability Digital Power Amplifier
8 Channel Class D High Stability Digital Power Amplifier
|Channel number||2 channel||4 channel||6 channel||8 channel|
|Circuit category||Class D|
|Height||1U (44mm)||1U (44mm)||2U (88mm)||2U (88mm)|
|Output power 4Ω||500Wx2||500Wx4||500Wx6||500Wx8|
|Output power 8Ω||300Wx2||300Wx4||300Wx6||300Wx8|
|Bridge output power 8Ω||1000W||1000Wx2||1000Wx3||1000Wx4|
|Distortion ( 1kHZ, 10 dB/4Ω)||＜0.2%|
|S/N (20Hz-20K hz, 4Ω)||＞112dBA|
|Cross Talk (1k HZ, 4Ω)||＞35 dB|
|Frequency response||10Hz to 20k Hz,+/-1dB|
|Input Impedance||balanced 20 K/ non-balanced 10 K|
|Damping factor(10-400 Hz, 8Ω)||>300|
|Protections||Protections against short circuit, over-load, overheat, direct current, radio-interference, on/off switching, muting and amplitude limit.|
|Control Knobs||Power on/ off switch in front panel, gain control in front panel, Mono and bridge selection on rear panel|
|Led lights||Clip/ -10 dB/ signal/ Mono/ bridge/ Status/ Active/ Protect indication light on front panel|
|Air flow||The air flow is from front to back of the amplifier.|
|Power delay||4 seconds|
- Syber exclusive design. 2 Channel/ 4 Channel/ 6Channel/ 8Channel optional.
- Powerful output and long lasting stablility.
- 1U/ 2U height, light weight and easy to move and install.
- Class D Topology integrated with switch power supply design.
- High efficiency and Low electricity consumption.
- Fully protetions against short circuit, over-load, overheat, direct current, RF, on/off switching, muting, and amplitude limit.
- Stereo, bridge and mono mode selection switch is set on back panel.